Quantity on hand: 5
There are 0 on order
Recommended for Indoor Use Only
- Measures from 1'-6" Up To 45 Feet (13 meters)
- Computes areas and volumes
- Adds linear measurements, area, volumes
- Measures in Ft/In, M/Cm
- Tracking and Validate Modes
- Automatic internal temperature compensation
- Auto shut-off 7 minutes after last use
- Multi-lingual Detailed instruction booklet
- Multi-lingual Quick Reference instruction label
- Low Battery Warning ("BATT"
shows on the display when your batteries are low).
-
Requires One 9 Volt Battery (not included)
- Accuracy 99.5% +/- ¼" (1cm) (formula for margin of error: i.e. 20' x 12" x .005 = 1.2" +/- ¼" at 20
Feet)
- One Year Warranty
Electronic Distance Measuring Tool
- Sends out narrow beams of sound waves which "bounce" off solid
objects back to the hand held receive. Custom electronics and a microprocessor
convert elapsed time into a distance measurement and display it on the LCD.
Measures from 1'6" Up To 45 Feet
- Requires 1 square foot of perpendicular hard surface for every 10' of
measured distance ( at 30' a door or window is adequate)
Computes areas - Length x
Width = Square Feet - Measure length then press (X) key. Measure Width then
press (X) key. The total square feet will show on the display ( sq2 ).
Computes volumes - Length x
Width x Height = Cubic Feet - Measure Length then Press (X) key. Measure Width
then press (X) key. Measure Height then press (X) key. The total cubic feet will
show in the display ( ft3 ).
Adds linear measurements, areas,
volumes:
- For Adding Linear Measurements - Take first measure meant the press (+) key, take second measure then press (+)
again etc.
- For Adding Areas or Volumes:
Compute area or volume as show above then press (+) key (this stores the area or
volume in the (+) memory). Compute your next area or volume and then press the
(+) key again. Your grand total area or volume will be displayed (example: L (X)
W (X) H (X) (+) L (X) W (X) H (X) (+).
Measures in Feet/Inches,
meters/centimeters, - Unit defaults to Feet and Inches. After taking
your measurement hold down the ( C ) key until desired mode is reached. This
will change the mode.
Tracking and Validate Modes -
You can track a distance and/or validate a distance.
- Tracking - Hold down tracking
bar to track a distance. Unit will taken continuous readings.
- Validate - When you have
reached your distance, validate the measurement by pressing then releasing the
validate bar. The unit will take several like measurement before giving you a
reading. (It validates itself.)
Automatic internal temperature
compensation - To obtain the temperature of the internal boards press
the (+) key and measurement bar at the same time. This is helpful for accuracy.
(example - If the unit is kept in a car on a sunny day or in your pocket on a
cold sunny day, you can check the temperature to be certain that the unit is the
same temperature are the area you are measuring. If you are off, then wave the
unit to acclimate to the current measuring temperature to ensure accuracy within
specs.
