Features:
- 3 digit digital display shows CO level when higher than 30ppm
- Permanently installed semiconductor sensor
- Peak level recall button
- 9 volt battery backup in event of AC power failure
- Mounts on single, gang or 4" octagon junction box
- Convenient pull-out drawer for easy battery replacement
- Battery pull-tab (activates battery and reduces installation time)
- Low battery audible indicator
- Can be interconnected with up to 18 Universal brand CO alarms (with 12
smoke alarms maximum)
- When one CO detector unit goes into alarm, all interconnected CO
units sound their alarm (will not sound smoke or heat alarms that are
interconnected)
- Test button
Specifications:
- Sensitivity and tolerance (alarm will
sound):
- 70 ppm within 60 to 240 minutes
- 150 ppm within 10 to 50 minutes
- 400 ppm within 4 to 15 minutes
- LED indicators:
- Red: alarm condition when LED is flashing
- Yellow: fault condition
- Green: AC power indication
- Voltage: 120 vAC (60Hz) 0.1 Amp
- Standby Battery: super heavy duty carbon
zinc (installed in "QUICK DRAW" battery drawer with Mylar pull-tab
- Voltage (DC Standby)
- Normal 9V @ 4.0 mA
- Alarm 9V @ 10.5 mA
- Wiring: AC Quick Connector with
semi-stripped wires
- Sound level: 86.7 dB at 10' down to 7.75
vDC
- Acceptable backup batteries ONLY:
- Alkaline: Eveready 522 or Duracell
MN1604
- Lithium: Ultralife U9VL-J
- Battery life: approximately 1 year
- Weight: 7 ounces / 195 grams
- Dimensions: 5⅜" ø x 1¾" high
Supplied with:
- Mounting plate
- Warning/safety labels
- Wire harness
- Instructions & installation manual (download
pdf version)
- Battery
- Five year limited manufacturer's warranty
| 
