Infrared Portable Motion Alarm (HS5300) with Digital Keypad & 105dB Siren

• 90° motion sensor is adjustable for optimum sensitivity
• Selectable entry delay: 5 seconds, 10 seconds or 15 seconds
• Adjustable alarm duration time: 30 seconds, 60 seconds or 90 seconds
• Select between 2 sounds
  • LOUD 105 decibel siren
  • Chime tone
• Has an "Emergency Panic Button"
• Keypad with selectable personal security code
• Portable - Place on wall, floor or table
• Low battery indicator
• Intrusion memory indicator
• When you disarm the unit, the LED flashes three times, indicating an intrusion during your absence.
• 90 day limited warranty
• Power: 9v battery (not included) or optional power adapter {9 Volt DC >200mA AC Adaptor (not included) with a 3.5mm diameter male plug, center positive (+)}

Unit is not weather proof. Do not install the alarm where it will be exposed to direct sunlight or rain.

Supplied with:

• Instructions
• Door and window warning decals
• Wall anchors & screws (wall mounting hardware)
• 90 day limited manufacturer's warranty

Download User Manual (PDF format)

PROGRAMMING
NOTE: When you first install the battery, the initial security code set by the factory is "0-0-0". You can program your own security code (up to 6 digits). If more than 6 digits are entered, you will hear an error tone.

• To change an existing code to a new code:
  • Enter the old code number (0-0-0 is factory preset)
  • Press the "PROG" button
  • Enter your new security code (1 to 6 digits)
  • Press the "PROG" button again
• To program the alarm duration time:
  • Press the "PROG" button
  • Press either 1, 2 or 3 for different timing:
    1 = 30 seconds alarm - 2 cycles, 30 seconds rest in between (preset timing)
    2 = 60 seconds alarm - 2 cycles, 30 seconds rest in between
    3 = 90 seconds alarm - 2 cycles, 60 seconds rest in between
• To program the entry delay timing:
  • Press the "PROG" button
  • Press either 7, 8 or 9 for different timing:
    7 = 15 seconds delay (preset timing)
    8 = 10 seconds delay
    9 = 5 seconds delay

NOTE: Programming can only be performed in the "Disarm" mode. When the unit is in "Arm" mode, no programming is allowed for added protection.

OPERATION

• To arm the unit:
  • Enter your security code (or "0-0-0" if you did not change the code)
  • Press "ARM." You will hear three short beeps to confirm the unit is armed

  NOTE: Be sure to switch off the chime switch before arming. There will be a 60 second exit
  delay after arming the unit.

• To disarm the unit:
  • Enter your security code
  • Press "DISARM", you will hear one long beep to confirm the product is disarmed
  • Chime on/off:
    • Slide the chime switch to "ON"
    • Wait 60 seconds for the sensor to warm up. Then, when motion is detected, the product will sound the chime
    • Slide the switch to "OFF" to turn the chime function off

    NOTE: When the sensor alarm is in "Arm" mode, the chime will not function

• Panic button:
  • Press the "PANIC" button to trigger the alarm immediately for 30 seconds
  • To stop the alarm, enter your security code and press "DISARM"